Blue water comfy bed

Sealord athwart ship bed layout:

Sleep is, for us, without question a crucial commodity on board and is right up there at the top of the list along with fresh water, fuel, food, power and wind.

A bed needs to be comfortable yet firm, well ventilated, cool and not in the habit of rolling you around when you are trying to sleep.

Our Sealord arrangement in the aft cabin was originally set up with two longitudinal berths, one single and one pretty miserly double with feet under the aft locker, somewhat like a trotter box arrangement. We had found this to be far too cramped even for the short summer holidays we used to spend in it but, worse than that, on the few occasions we slept at anchor in those days, totally impractical when the boat rolled.

Arrangement before re-model

It was certain that this layout was unsuitable for long term cruising where we would leave marina living behind for years at a time and be at anchor or on passage for the vast majority of our adventure.

When measured up it was clear that, with the bed across the boat (athwart ships), a full size standard mattress would just about fit. It would also be possible to make storage space at both the head and the foot for the tanks I wanted to fit for drinking water and an above waterline holding tank. In the crystal clear

Building headboard-tank bulkhead

waters of a South Pacific anchorage a holding tank is obviously important when you frequently swim off the boat and placing it above the waterline is a far, far more sound idea than below. Separating drinking water from the general fresh water system allows its contents to be much better managed and protected (see ).

In any case, it was clear that sleeping athwart ships would be more comfortable even in a

Ply frame, pivot and tank openable tank access

moderately rolly anchorage but also, if the space under the aft lockers were left clear for our feet then we could also comfortably sleep there solo when the boat was heeled to port or starboard on passage.

The tops of the lockers were all the same height so minimal changes to the woodwork would be necessary to seat the mattress. The biggest drawback with the scheme was that access to the now huge storage area under the bed would be made more difficult. This was overcome by

Bed swings up to provide storage access

making an independent plywood frame for the bed which would be stiff and light enough to swing upwards on built in pivots. A well ventilated plywood slatted support system (from Victoria Yachting) was mounted on top of this frame.

Gas struts

With the mattress in place this is still heavy and awkward to lift so supporting gas struts were used to balance the system. These are cheap, robust and adjustable to different loads by degassing with a small adaptor tool. They made the area under the bed space easy to get at and could be locked down on a single, simple spring latch.

Stbd tank behind hinged access bulkhead

There was also now room to fit a small locker to sit in the front of the bed to provide additional storage and a retractable step up into the bed. This arrangement is sealed at the back so, in the event of severe water ingress from anywhere aft, flooding would be slowed down somewhat.

A further benefit of the arrangement on our boat turned out to be that, by running a net across the access to the bed area, it could be easily isolated against mosquitoes, a major consideration for some areas of the tropics.








Mosquito net

Added locker

Added ventilation is provided by 2 dorade vents on the aft coach roof, opening side port lights which are sheltered from tropical downpours with a low level awning and finally 2 electric fans connected into the lighting system. These inexpensive fans are probably one of the most essential electrical accessories for on board comfort fitted to Camomile and, even if you have air conditioning (which you will struggle to run because of it’s appetite for diesel), are a must.

Finished arrangement

All this may sound like overkill but when we are in the tropics we have found the arrangement to be a minimum when the night time air temperature is more than 25 degrees and the sea water even warmer.Fitted with an inexpensive 6’x4’6”x6” solid foam mattress (to avoid rusty springs) on top of the supporting slatted suspension system, with upholstered headboards at both ends and foot rests down under the aft lockers we can not only choose which way around to sleep according to the conditions but have found this to be the most comfortable and adaptable beds we have ever owned bar none. I often wonder how anyone manages with anything else on board.

If you have any questions, queries or further ideas relating to this article or others please don’t hesitate to mail them to me on the addresses shown in Contact Us. All feedback is welcome and reading it gives the old man something to do when it rains.

  1. You need to take part in a contest for one of the finest sites on the net.
    I most certainly will highly recommend this site!

  2. We passed briefly in Tioman and I have just found your site, catching up reading the adventures as well as looking forward to future posts. Must say a massive thank you for this post in particular which has inspired a re-model of our access to the forward berth lockers with one hinged with gas struts 🙂

Leave a Reply to saltygardener Cancel reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: